The PanelDue 7i is a colour touch screen controller for the Duet and other 3D-printing electronics that support it. The integrated version is a custom-made high-quality 7-inch or 5-inch TFT LCD panels with 800x 480 pixel resolution from a leading manufacturer, with the PanelDue controller integrated on the LCD’s PCB.
Alternatively, the control board can be purchased without a screen. In this case a SSD1963 LCD panel is required in one of 3 screen sizes/resolutions: 4.3″ (480×272), 5″ and 7″ (800×480 pixels).
|Resolution||5i and 7i = 800x480 pixels|
|Connectivity||A 300mm long ribbon cable (maximum recommended length) is supplied for the on board SD card, power and serial data. Alternatively if the onboard SD card is not required then a 1m long 4-wire cable for the serial and power connections is also supplied|
|Voltage||5V power from the host 3D printer controller. 2-wire async serial interface with 3.3V signal level (5V tolerant input)|
|Firmware||Runs PanelDue firmware: PanelDueFirmware|
An advanced, high power controller that features support for 6 external stepper motor drivers, along with similar outputs and IO as the Duet 3 Mainboard 6HC.
An advanced, mid range controller that features 5x 2A stepper drivers, 3 high current heaters, 4 fans and more
Duet 2 is an established and proven 32 bit electronic controller for 3D printers and other CNC machines.
A 5 driver expansion board for the Duet 2 Wifi and Ethernet.
This is a daughterboard specifically designed for the Duet 2 and Duet control boards that allows two Thermocouples to be attached.