SD card on paneDue 7" not reading

Avatar

By ronnien59 26 January 2017 13:13

Member · 58 comments

I am trying to get the PanelDue 7" screen to read from its internal SD card slot, however it comes up with an error. " Error 1 accessing SD card" Can someone help with this?

Avatar

By dc42 26 January 2017 14:10

Administrator · 1,867 comments

Do you have a 10-way ribbon cable connected between the PanelDue and the Duet WiFi, as well as the 4-pin main cable?


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By ronnien59 26 January 2017 15:17

Member · 58 comments

No I do not have a ribbon cable installed.

Avatar

By T3P3Tony 27 January 2017 07:11

Administrator · 579 comments

There is some more information here:

https://duet3d.com/wiki/Connecting_an_L … _LCD_panel


Duet Wifi Hardware Designer
www.duet3d.com
www.think3dprint3d.com

Avatar

By ronnien59 28 January 2017 01:46

Member · 58 comments
T3P3Tony wrote

There is some more information here:

https://duet3d.com/wiki/Connecting_an_L … _LCD_panel

Thanks I have order one this evening.

Avatar

By ronnien59 1 February 2017 12:10

Member · 58 comments

Okay,
I have connected the 10 pin ribbon cable between PanelDue 2.0 7" and Duet WiFi and I am still getting an error. I have the latest software loaded on the DuetWiFi board. Am I missing something? I have looked at the documentation and all seams to be correct pin to pin as laid out. It still will not read from the card.

Avatar

By dc42 1 February 2017 13:45

Administrator · 1,867 comments

Can you post photos showing how the ribbon cable is connected to the PanelDue and to the Duet WiFi? How long is the cable?


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By ronnien59 1 February 2017 20:34

Member · 58 comments

Here you go DC42
the length is 800mm
duetwifi.jpg?raw=1
paneldue.jpg?raw=1

Last edited by ronnien59 (1 February 2017 20:41)

Avatar

By dc42 1 February 2017 21:19

Administrator · 1,867 comments
Avatar

By ronnien59 13 February 2017 19:52

Member · 58 comments

Okay, I have tried the 400mm and also the 200mm ribbon cable and it still has the same error as in the beginning. It will not read the SD card inserted in the PanelDue 7".  Any other place to look?

Avatar

By dc42 13 February 2017 21:08

Administrator · 1,867 comments

Your connections look correct to me. Does the same SD card work in a PC? Is is formatted as FAT32?

The PanelDue controller board just connects the SD card pins on the 40-way connector to the pins on the 10-pin connector. Power for the SD card is provided by the TFT panel.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com