Duet wifi controlled dbot corexy based

Avatar

By Dracula36 22 March 2017 22:14

Member · 19 comments

hi, I have a problem with g32 after running it I will lower the level of 5mm and of the press away from the nozzle ... how can I fix this? I not really understand where I'm wrong

Avatar

By dc42 22 March 2017 22:27

Administrator · 2,617 comments

Sounds like you haven't set your Z probe trigger height. It's the Z parameter in the G31 command in config.g.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By Dracula36 23 March 2017 06:07

Member · 19 comments

It has been set that value
G31 Z-0.02 P50

p50 for a npn probe is correct? When I probe with G30 S-1 it works well ... with G32 instead of the dish does not rise up to the nozzle ... as I installed firmware 1.18 beta 1 could be the problem?

Avatar

By dc42 23 March 2017 13:15

Administrator · 2,617 comments

If you have an inductive probe then Z-0.02 in your G31 command is definitely not correct. You need to put in whatever height the probe triggers at in the Z parameter. The P parameter is much less important, but P100 or lower gives you the fastest response and on debouncing.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By Dracula36 23 March 2017 13:54

Member · 19 comments

I'm sorry that I have to put in value g31 z ??

Avatar

By Nuffe 23 March 2017 16:16

Member · 18 comments

https://miscsolutions.wordpress.com/min … sor-board/ has quite good explanation. It is for IR probe but search for g30 s-1 and around there is the process to figure out Z for g31 described.

Z parameter tells for g31 at what height the probe triggers. Because it is not going to trigger at 0 and not at -0.02 as you have currently defined.