I got my bltouch, and it did not come with resistors, so I contacted my distributor. They got back to me today and informed me there is a new design that has an option to break a small lead on the body of the bltouch to activate 3.3v output.I can supply the documentation when I get back to my computer, but this info should be on cube8llc eBay page shortly.Sorry wrong address, I corrected it
Last edited by 3dprinting meathead (13 February 2017 02:21)
If I can learn it, than anyone can learn it.
would luv to see more on this
think i found ebay post with a ton of links...http://www.ebay.com/itm/BLTouch-Auto-Be … Sw9GhYZDui
maybe im blind but I dont see anything that mentions breaking a lead for 3.3v?
It's the second to last of the photos provided. The photo of the bltouch in the package hasn't been updated.
Yup, the one in the picture matches the one I got. I'll see if i can link a picture with my meathead skillsI guess you take a razor blade and cut the little tab connecting the 2 points. Havn't done it yet, but maybe this weekend.
Ok, I just cut the tab.It's kinda a pain.
the best way I found was to use the back side of a utility knofe blade corner, it's pretty much the exact width of the jumper, and it scrapes out the jumper, instead of cleanly slicing through it and not removing it, as that could potentially short later.