End Stop Wiring

Avatar

By dklassen 5 February 2017 15:58

Member · 9 comments

Can someone help me with how this should be wired to the Duet Wifi. Not sure the pinouts are correct.

endstop.jpg

Avatar

By FrankNPrinter 15 February 2017 13:19

Member · 7 comments

this might help as i am doing the same thing now. i noticed the pins are labeled on the sensor. nc= normal closed and no is normal open and common

Avatar

By dc42 15 February 2017 17:53

Administrator · 1,867 comments

The complication is the LED. The Duet has an LED attached to the endstop input too, and if you wire it that endstop board incorrectly, you may get a situation in which the endstop doesn;t reliably show as triggered or not triggered in one of the states.

Are the connector pin numbers not marked on the board? Can you give me a link to the schematic for that board?

At a guess, The red wire goes to +3.3V, the black wire to Gnd, and the green wire to STP on the endstop connector.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com