See https://github.com/dc42/PanelDueFirmwar … /tag/v1.16 for release notes and binaries.
Duet WiFi hardware designer and firmware engineerhttp://www.escher3d.comhttps://miscsolutions.wordpress.com
where should we post request for new features for the PanelDue? this thread?
Thank you David! will update shortly!!
One Day At A Time... My Main Research Page:http://rwgresearch.com/open-projects/3d … -research/
oh also, we still can not update this through the duet correct?
ok, i got it updated using Win 10.
using Command line bossac found here: https://github.com/dc42/RepRapFirmware/ … ls/Windows
win 10... oh boy...
any how, i havent updated sence V 1.13 i think it was, and the colors i have on my screen from 1.13 to the last 1.16...
well the colors are total wack IMO. they look " puke'e"
is this normal?
here is the one from your site, it looks SO much better? Thanks!
Last edited by Russ Gries (7 April 2017 23:49)
Looks like you've loaded 5" firmware when you have a 7" screen, or vice versa.
the file i uploaded was labeled : "PanelDue-7.0-1.16.bin"
Ill try it again Monday. this is a 7"
any other ideas let me know...
Awesome! Will flash this just because the Emergency button 😁
E3D Bigbox dual
ok, all is fine now that i put the 5" LCD firmware on the 5" LCD...
haha i must have lost my marbles...
all is well,
So far so good 😁 I only wish the emergency button would be visible on the "Move head" screen as well.
While i was doing a bed level i tried to hit the STOP on the Panel Due.
it did not respond.
can some one else check this?
it should stop correct?
Which firmware are you running on the Duet? You need version 1.18 to get a fast response from the emergency stop button on PaneDue.
A true emergency stop button is an electrical switch that disconnects the power to the printer.
1.18.1 duet WIFI
I hit it over and over to try to get it to respond but it never did. ( press and held it)
just wanted to point this out.
it responded right away on the web interface..
I decided to run some G code and try it. (octagon-test-delta.gcode)
it responded right away also.
but when doing a mesh grid ruteine it works fine. everything stops.
its only when I'm running a bed level ruteine.
ok, now I'm confused... now after Manny restarts its working fine now.
wonder if anyone else has come across this??
Last edited by Russ Gries (17 April 2017 21:40)
I have not updated to 116 Yet but I am on 115C
I do not know if this feature is already in the PanelDue.
But I would like for the PanelDue to read the Default Heater Temperatures and Default Bed and Chamber Temperatures setting.That I configed through the Duet Wifi web site,
Do I can choose them for the Bed and hot-end temp
Do you mean the settings that you have set the heaters to? Or do you mean the selections available on the drop down list?
I use macros to set the bed and hot end temperatures for the filaments that I commonly use.