Problem G02/G03 commands DuetWiFiFirmware-1.17e

Avatar

By RubenG 20 March 2017 13:05

Member · 3 comments

I was trying to use my printing system as a laser engraver using the Inkscape Laser Tool Plug-In.
This program outputs a gcode with G01 and G02/G03 commands.
Currently, I am using a Duet Wifi so I installed the DuetWiFiFirmware-1.17e which includes the G02/G03 commands recognition.
However, the machine was not responding as I was expecting. Then I erased the Duet Wifi and installed everything again, without success.
So I tried the following code the find the problem. For now, I just used a pencil to plot the movement.


G90
G21
G01 X10 Y25
G02 X10 Y25 I20 J0 F125

In my case the X -axis is mirrored which should not matter in my opinion.
IMG_20170320_121618.jpg?raw=1

And when trying:
G01 X10 Y25
G03 X10 Y25 I20 J0 F125

It gave the response shown in the blue dotted line.

As I understand the G02/G03 commands, the machine should start its circular motion directly at X10 Y25 instead of moving to the Y25+ radius first.
Is there a way this problem can be solved?

Last edited by RubenG (20 March 2017 16:50)

Avatar

By dc42 20 March 2017 16:09

Administrator · 2,617 comments

Please can you check that image link because it doesn't work for me.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By RubenG 20 March 2017 16:52

Member · 3 comments

Is it visible now?

Avatar

By dc42 20 March 2017 21:19

Administrator · 2,617 comments

Yes, it's visible now. I'll try that out tomorrow.


Duet WiFi hardware designer and firmware engineer
http://www.escher3d.com
https://miscsolutions.wordpress.com

Avatar

By RubenG 19 April 2017 14:08

Member · 3 comments

Is there any progress on the G2/G3 commands?